SCCM Client Install – Could not access network location %APPDATA%

Today I was troubleshooting an SCCM Client install issue. checking the CCMSetup.log file the setup was returning “Could not access network location %APPDATA%”

To resolve this issue I updated the appdata location under the following registry key

the location was set to “%APPDATA%” instead of “%USERPROFILE%\AppData\Roaming”

after updating this location I was able to successfully install client.

after doing some additional research on this issue I found that you should also check the following locations.

 

Leave a Reply

%d bloggers like this:
çiğli escort bornova escort karşıyaka escort üçyol escort bayan escort denizli eskort antalya antalya eskort bayan escort antalya izmir eskort bayan izmir eskort bayan eve gelen escort escort bayan izmir karşıyaka escort